How do I fix the error on my LG top load washer?
How to fix LG washing machine DE error code?Step 1: Tap the Power button to turn off the washing machine and remove the power.Step 2: Once the power has been disabled, press and hold the Start/Pause button for about 5 seconds.Step 3: Plug the washer back in and switch on the unit by pressing the Power button.
Where is the reset button on a LG washing machine?
Sometimes the motor and the control panel don’t communicate initially, resulting in this error code. To reset this issue, the manufacturer advises to unplug the machine, press the Start-Pause button, and hold it in for 5 seconds before restoring power by plugging it into the outlet.
How do I run a diagnostic on my LG front load washer?
Press the POWER to turn on the washer. Place the mouthpiece of your phone between the Smart Diagnosis logo and the POWER button. After pressing the Start Diagnosis button, press and hold the TEMP button until a countdown displays on the washer. Keep the phone in place until the tone transmission has finished.
Why is my LG washer not getting water?
LG Washer fills slowly or will not fill at all If the water inlet valve is defective, the wash may fill slowly or not fill at all. If the water pressure is adequate, try cleaning the screens inside the water inlet valve hose connection ports. If the washer still fills slowly, replace the water inlet valve.
What causes a washer not to fill up?
If your washer if not filling, start by making sure the faucet at the water-supply end of the hose is turned on. If you have un-kinked hoses that are tightly attached and with clean screens, and you have good water pressure, the next place to check for a water-filling problem is the water inlet valve.
How do you diagnose a washing machine problem?
Remove the power source to the washer before troubleshooting or attempting repairs.#1 – Washer Won’t Turn On.#2 – Not Draining Properly.#3 – Will Not Spin and/or Agitate.#4 – Washer Leaking Water.#5 – Does Not Dispense Detergent.#6 – Washer is Shaking and Moving.#7 – Washer is Noisy.#8 – Washer Smells.
Where is the water inlet valve?
The inlet valve can be found on the back of your washing machine. Its principal responsibility is to manage the entry of water into your washing machine. In other words, the inlet valve acts as a sort of gate keeper, allowing water to flow into the tub when it receives certain electrical signals from the washer.
How do you fix hammering water pipes?
Follow these steps to try and resolve water hammer:Shut off water supply to the house at the main.Open all the cold water faucets, start with the highest faucet (2nd or 3rd floor) and work to your lowest faucet (first or basement floor).Flush all the toilets in the home.Let water drain from open faucets.
Will water hammer damage pipes?
In addition to being annoying, water hammer can be so forceful that it can break pipes or loosen plumbing joints. Note: Although you don’t hear it as loudly, water hammer can also be an issue with plastic water supply pipes, such as CPCV and PEX. And the potential danger for pipe damage still exists.