Why is there water left in the fabric softener compartment?

Why is there water left in the fabric softener compartment?

What causes water to be left? This tube often gets blocked by the fabric softener itself. If you remove the dispenser drawer and take off the cap or device you can give the whole thing a good clean out. The remaining water should slowly siphon out of the hole under the cap and run out from the bottom of the drawer.

At what point does fabric softener get dispensed?

The softener is intended to be released into the washer during the rinse cycle. Most of the older top load models had you add fabric softener to the center agitator which would then be released into the tub during the spin cycle and thus be added to the rinse cycle which followed.

Why is my Indesit washing machine not taking fabric conditioner?

If your machine fails to remove the fabric conditioner from the appropriate compartment, it is likely there is a blockage within the detergent dispenser itself. We recommend you remove the detergent dispenser drawer and clean using hot soapy water to remove any blockages and re-try the wash process.

Why isn’t my Zanussi washing machine taking the fabric conditioner?

You need to poke something in there like some garden tying wire and push it right in there. As this will clear any muck in the channel in the roof. Then this usually cures the problem and the washer should start to take the softner from there. If not then the soap dispenser roof will need to be replaced.