Why is my washing machine not getting cold water?

Why is my washing machine not getting cold water?

Check that the cold water tap for the washer is turned on and also that water is available from the tap. Check that the filter in the end of the cold water inlet hose connection into the washing machine is not blocked. Check water filter on hose is not blocked. Check cold water tap is working.

How do you hook up a washing machine to only use cold water?

If you want to connect up a washing machine that uses hot and cold water (and therefore has a hot & cold fill valve) but you only have a cold water supply available, you can use a Y Piece connector to connect it up to a single cold water tap.

Why is my Amana washer leaking from the bottom?

Common solutions for: Amana Washer leaking water The drain pump pumps water out the drain hose. If the drain pump is cracked or damaged, or if the bearings are worn out, the drain pump may leak water. For this reason, if the tub seal is leaking water, replace both the tub seal and the tub bearings.

How do I reset my Whirlpool auto load sensing washer?

Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset. You can run a test load without any clothing to ensure that the reset worked.

How do you adjust the water level on a Whirlpool washer?

If you would like the machine to automatically sense the appropriate water level for the load size and type, turn the Water Level knob to the Auto Sensing setting. If you would like to add the maximum amount of water to your wash cycle, turn the Water Level knob to the Deep Water Wash setting.