Why is my washer not rinsing and spinning?

Why is my washer not rinsing and spinning?

There could be a variety of problems causing the rinse cycle not to work, including a broken or clogged drain pump, a bent or clogged drain hose, or a broken switch assembly.

Why does my washer keep stopping?

Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining. One thing that you can check yourself is the lid switch.

How do I put my GE top load washer in diagnostic mode?

Test Mode is initiated by pressing a sequence of buttons on the washer’s control panel.Press the “Power” button on your GE washer. Unplug the power cord for at least 30 seconds.Plug the power cord back in to the GE washer. Press “Delay Start” to advance to “t02”.

How do you manually unlock a GE top load washer?

To unlock the lid, follow the procedure below.Step 1: Remove the four screws and the back panel.Step 2: Remove the two screws holding the top cover on. Step 3: Now the top cover can be removed. Step 4: Place a small screwdriver in the hole in the lid lock to unlock it.

Why is my GE washer not draining or spinning?

If the washer drains properly, then the clog has likely cleared. If water remains in the washer, check for a pinched or flattened drain hose. If you clear a clog, press START to resume your cycle, or you can select Drain & Spin and press Start. If the water drains, then the clog is clear.