Why is my Maytag dishwasher not draining?

Why is my Maytag dishwasher not draining?

Common solutions for: Maytag Dishwasher not draining. The drain pump uses an impeller to force water through the drain hose. If the drain pump motor is not working, the dishwasher won’t drain. To determine if the drain pump is defective, check the pump motor for continuity using a multimeter.

Why is the bottom of my dishwasher full of water?

Water in the bottom of the dishwasher results from clogs in the filter, garbage disposal, drain hose, drain pump, or air gap. When food or sediment build up within these systems, the dishwasher won’t drain properly. Locating the blockage and clearing the debris will solve the problem.

How do you troubleshoot a Maytag refrigerator?

1. The Refrigerator isn’t cooling or is too warmAdjust the temperature. Check the settings. Check if vents are obstructed. Make sure the icemaker is turned on. Check if the water line is kinked. Make sure water shut-off valves are fully open. Make sure the door is sealed properly. Wipe down the door seal gasket.

How do I reprogram my Maytag refrigerator?

Press and hold the Freezer Temperature Down keypad within 3 seconds. Release the door alarm keypad and wait 3 seconds. The control will display PE to indicate the programming mode. Press the Freezer Temperature Down once more.

How do I reset my Whirlpool refrigerator control board?

Reset power to the product:Power unit down by turning off the circuit breaker(s) or unpluging the product for 5 – 10 minutes.Power unit up by turning on the circuit breaker(s) or plugging the product back in.Ensure the cooling function is turned on.Test the control panel functionality.

Why is my ice maker not working whirlpool?

If your ice maker isn’t producing ice at all or is producing crescents or cubes that are smaller than usual, it’s typically indicative of a clog somewhere along the supply line. Cause: A common cause for a clog is frozen water in the line. Fix: To repair a frozen line, slide the refrigerator and unplug it.

Where is the reset button for Whirlpool ice maker?

Look for the Reset Button To access it, you must first remove the ice tray. Once you do that, you should see the bright red reset button on the bottom of the ice maker itself. To reset the ice maker, push this button in and hold it for 10 seconds.

How do I reset my Whirlpool water filter?

Press and hold the “WATER FILTER” button for 3 seconds. When the system is reset, the water filter icon will return to its BLUE color and the words “Replace Filter” will disappear from the display.

How do I reset my water filter?

4 Remove the old water filter and install a new one when the filter indicator is red. Reset the filter indicator by pressing Alarm/Hold 3 sec for Filter Reset button for 3 sec. The filter indicator turns blue, yellow, or green when you reset the indicator.

Is it dangerous to not change water filter?

Failing to change your fridge’s water filter can cause scaling and deposit buildup in the water and ice machine, which can seriously damage your fridge. This buildup tends to slow down the system, causing low flow, and negatively affects the flavor of your water.