Why does my Kenmore washer stop mid cycle?

Why does my Kenmore washer stop mid cycle?

If the washer stops mid cycle the lid switch assembly might be defective. This is a very common problem. The lid switch assembly can fail either mechanically or electrically. Most washers have a cold water rinse and so if they can’t fill with cold water they just sit indefinitely waiting for the cold water to enter.

Why does my Bosch washing machine stop mid cycle?

Common solutions for: Bosch Washer stops mid cycle If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer may stop mid-cycle.

Why is the wash light flashing on my Bosch washing machine?

This occurs after water has entered the soap compartment, usually after a few minutes. Re-setting the programme normally allows the wash to proceed but sometimes more than one re-setting is needed.

Where is the reset button on my Bosch dishwasher?

To reset the modern Bosch dishwasher, press and hold the start button for about 3 to 5 seconds. On some older Bosch models, the reset feature may be called “cancel” or “drain”. These older models require a specific Button Press Sequence or what we in the biz call a Key Dance to complete.

What is e17 error in Bosch washing machine?

Washing machine troubleshooting: Error codes E17 or F17 These error codes indicate that the water supply time has been exceeded.

What does Error 2 mean on a washing machine?

This is an error message signaling the unit’s inability to drain properly within a time specified by the PCB software. Cause 1: blocked pump filter. Extract the pump filter and clean it. To get to the filter, open the filter access door at the machine’s bottom right corner.

How do I fix my f18 Bosch?

This could happen for several reasons: blockage inside the filter, blockage inside the draining hose or a problem with the pump. How can I troubleshoot for the washing machine error code E18 or F18? To fix this, reset the washer by turning it on then off. Also, remove debris from the drain pump.

Where is the drain pump on a washing machine?

The drain pump may be located behind removable panels in either the front or back of the washing machine, even underneath the appliance, requiring you to tip the machine forward to access it (consult your owner’s manual for instructions). You’ll see a drain hose and inlet hose connected to it with spring clamps.