Why does my Bosch washing machine not drain?

Why does my Bosch washing machine not drain?

Common solutions for: Bosch Washer won’t drain. Sometimes, small objects or articles of clothing can get caught in the drain pump. Sometimes, socks and other small articles of clothing can get into the drain system and clog the pump hose or the pump itself. Remove the hoses from the pump and check for any obstructions.

What is e3 error in washing machine?

The E3 error in Samsung washers means a drum overflow with water. The water level sensor sends a signal indicating that there is too much water in the drum. The E3 error code indicates overfilling with water. That’s what this error, displayed on the washing machine, means.

What does e3 and f5 error code?

The F5 E3 alert indicates there is issue with the lid lock. Do not force the lid open, as permanent damage could occur. Touch POWER to exit cycle, then touch POWER again to release lid. If this is unsuccessful, reboot the machine by unplugging the washer and wait two minutes before plugging the machine back in.

What does e3 mean on heater?

overheated

What is EC code in AC?

A common error for Accent Air conditioning units. It means the refrigerant pressures are either too high or too low. There may be a lack of refrigerant or a faulty fan motor, capacitor or PC board.

What is e3 on Brother sewing machine?

The buttonhole or bar tack stitch was selected and the foot controller (or the start/stop button was pressed if the foot controller is not connected) while the buttonhole lever is raised. Lower the buttonhole lever before continuing the operation.

What is a buttonhole foot?

The button hole foot is a sewing machine foot which simply clips onto the machine. Remove your current presser foot, and then clip the buttonhole foot on. You can make a buttonhole with a 1 step or 4 step buttonhole setting on your machine. Don’t forget that this is the standard way to measure for a flat button.

What does e1 mean on a Brother sewing machine?

The foot controller was pressed (or the start/stop button was pressed if the foot controller is not connected) and the reverse/reinforcement stitch button was pressed while the presser foot is raised. Lower the presser foot lever before continuing the operation.

What is an e6 error on a Brother sewing machine?

This message is displayed when the motor locks up due to the problem such as a thread tangle or other reasons.

How do I fix the error code e6 on my Brother sewing machine?

“E6” error messageCheck your upper thread and make sure it is threaded properly. – Make sure that the thread take-up lever is threaded.Remove the bobbin and bobbin case. – Clean any lint or loose threads. Image may differ, depending on the model. The needle could be bent.

Why Does My Brother sewing machine keep jamming?

The tension could be too tight or too loose. Set the tension to the basic thread tension setting or adjust the tension manually. The combination of the needle size, thread size and fabric is incorrect. Be sure to use the correct size needle and thread for the type of fabric that you are sewing.

Why is my sewing machine bunching underneath?

A: Looping on the underside, or back of the fabric, means the top tension is too loose compared to the bobbin tension, so the bobbin thread is pulling too much top thread underneath. By tightening the top tension, the loops will stop, but the added tension may cause breakage, especially with sensitive threads.