Where is the filter on a Kenmore Elite dishwasher?

Where is the filter on a Kenmore Elite dishwasher?

The Kenmore Elite dishwasher filters are located on the right-hand side of the dishwasher floor. No tools are necessary to remove and replace the upper and lower filters. Simply turn the circular component of the upper filter counterclockwise 90 degrees and lift it out.

Why is my Kenmore dishwasher leaking from the bottom?

If the wash arm support is loose, water can spray out between the wash arm support and the lower pump housing, causing waveThese waves can cause water to leak out of the bottom of the door. Look for tears, gaps or cuts in the gasket that could cause a dishwasher door leak.

How do you fix a clogged Kenmore dishwasher?

The drain hose might be clogged. To unclog the drain hose, remove the drain hose from both the dishwasher and the sink drain and clean it out. The drain hose is most commonly clogged near the garbage disposer or dishwasher drain branch tailpiece.

What is wrong with dishwasher?

A dishwasher that won’t stop filling may have a faulty float switch, a timer stuck on fill, or a water inlet valve that is stuck open. If your door isn’t properly closed, the dishwasher will not start. If your latch is fine, check the timer or electronic control, especially if your drain pump motor isn’t starting up.

Is there a reset button on a Kenmore dishwasher?

A generic way to reset at Kenmore dishwasher is pressing the “heated dry” button then the “normal wash” button then again the “heated dry” then again the “normal wash”. After you press those four buttons in a row your dishwasher should begin a short 12 minutes test cycle during which the dishwasher will reset.