What would cause a washer not to spin dry?

What would cause a washer not to spin dry?

Washing Machine Drain Hose Clogged or Bent If the washer is not spin drying your clothing, check the drain hose on the very back of your washing machine. Make sure the drain hose is not bent therefore restricting water to drain out and leaving your clothing wet even after spin dry mode is complete.

Why is my front load washer not draining or spinning?

Check the Drain Hose or Pump for Clogs. It’s common for a sock or other small piece of clothing to get into the drain system and clog the hose or pump. Remove the front panel of the washer and check for any obstructions in these areas. If you find anything, remove it to see if you can get the washing machine to drain.

How do I get the water out of my washing machine that won’t drain?

Start by unplugging the machine and emptying the water. Bail the water out of the tub. Pro tip: Drain the tub using gravity by placing the washer drain hose on the floor near the drain or in a bucket. Clamp the hose to prevent any remaining water from running out.

Why is my Whirlpool washer not draining water?

When the drain hose is kinked, bent, blocked or clogged, the washer won’t drain. To handle the blockage problem, disconnect the drain hose and give it a good cleaning. Then, reconnect the drain hose to the machine, turn the electricity back on and run the rinse/spin cycle to see if the washer is draining properly.

How do I get water out of my Whirlpool washer?

Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.

Why does my Whirlpool washer fill with water?

Whirlpool Washer overflowing If the washer continues to fill with water even when it is not getting power, this indicates that the water inlet valve is defective. If the water inlet valve is defective, replace it. The pressure switch shuts off power to the water inlet valve when the proper water level is reached.