What does it mean when all lights are flashing on washing machine?

What does it mean when all lights are flashing on washing machine?

If the wash, rinse and spin function lights all flash at the same time, this would indicate a possible blockage in your filter or waste / drain pipe. We recommend checking your user manual as all models vary you can also download your user manual here.

What causes the spin cycle to stop working on a washer?

An unbalanced load of laundry is one of the most common causes of an inadequate spin cycle. Sometimes clothing can settle on one side of the drum, throwing off the motion of the washing machine. If you suspect a distribution problem, try rearranging your clumped-up wet laundry and running the spin cycle again.

What do you do when your washing machine won’t turn on?

1:52Empfohlener Clip 94SekundenTop-Load Washer Won’t Start Washing Machine – YouTubeYouTubeBeginn des vorgeschlagenen ClipsEnde des vorgeschlagenen Clips

How do I reset my Fisher and Paykel washing machine?

Is there a reset button on a Fisher and Paykel washing machine? Turn the dial to select ‘Spin’. Touch and hold the ‘Delay Start’ ‘More’ , the ‘Delay Start’ ‘Less’ and ‘Options’ buttons together for 3 seconds will appear on the screen and the machine will beep. Your washer will now be reset to the default settings.

How do you run a diagnostic on a Fisher Paykel washing machine?

How do you unlock a front load washer door?

How To Open A Front Load Washing Machine Door After Starting The Wash CycleHow to unlock washer door? Within at least 5 minutes of pressing the START/WASH button, press the START/PAUSE button to unlock the washer door. Now open the washing machine door once unlocked and add or remove any extra clothing.

How do you manually unlock a Whirlpool front load washer?

Hold down the “Control Lock” button on your Whirlpool washer for three seconds at the end of the washing cycle. You can manually unlock the washer by removing the top (remove screws on the back of the top panel and slide the top panel back to lift off.

Why is my Whirlpool front load washer not draining?

Common reasons for a Whirlpool Front Load washer not draining, not spinning, or leaving wet loads at the end of the cycle: Delicate or handwash cycle selected. Drain hose kinked or drain clogged. Drain hose more than 96” above the floor.

Why did my Whirlpool washer stop working?

Common solutions for: Whirlpool Washer stops mid cycle If the washer door is not latched shut, the door switch prevents the washer from operating. If the door lock is defective, the washer may stop mid cycle. The door lock can fail either mechanically or electrically. Inspect the door lock for damage.

Why is my Whirlpool washing machine not spinning?

If your Whirlpool Washer is not spinning the problem is almost always the lid switch. If the lid switch is bad you will not hear the motor running when in spin. To check the lid, first unplug the washer. Then you should see the lid switch and the wires going to the plug, remove them and install the new lid switch.