How do you take the front panel off a Maytag EPIC z dryer?

How do you open the top of a Maytag Centennial dryer?

1 Answer. I believe you will find two screws holding the top on located at the backside of the dryer. With those screws removed the top will come off. With the top removed the front panel retaining screws will be visible.

How do you open the front of a Maytag dryer?

How to Remove the Front Panel From My Maytag Clothes DryerUnplug the Maytag clothes dryer from the power source. Pull the bottom of the front panel toward you until the clips on the top of the panel release.Carefully disengage the wires from the door switch and set the door aside.Unplug the Maytag clothes dryer from the power source. Lift the door slightly and pull back.

How do you remove the bottom panel of a Maytag dryer?

To remove the lower front panel, there are 2 hidden metal spring clips above the top of the lower front panel in the crease. You need to slide a putty knife or flat head screwdriver over top of these metal spring clips and pry down. The lower front panel will then unclip at the top and pull forward and hinge down.

How do I clean the lint from my Maytag front load dryer?

To wash:Roll lint off the screen with your fingers.Wet both sides of the lint screen with hot water.Wet a nylon brush with hot water and liquid detergent. Scrub lint screen with the brush to remove residue buildup.Rinse screen with hot water.Thoroughly dry the lint screen with a clean towel.

How do you remove the front panel on a Maytag Bravos XL dryer?

How do you remove the front panel on a Maytag Bravos XL dryer?Unplug the Maytag clothes dryer from the power source. Remove the four screws.Lift the door slightly and pull back. The door and the hinges will disengage.The front panel of the Maytag clothes dryer is shaped like a goal post. Grasp the skinny, upper sides and wiggle them back and forth to unclip the panel.

How do you remove the front panel of a Maytag washer?

Locate the two screws securing the bottom of the front panel to the sides of the washer. Remove the screws with a nut driver. Swing the bottom of the front panel toward you and pull down to disengage the top of the front panel from the top panel.

How do I clean the lint from my Maytag Bravos dryer?

Use hot water and wet both sides of the lint screen. Use a nylon scrubbing brush and a little bit of liquid dish soap or laundry detergent to scrub the screen clean of lint and fabric softener buildup. Rinse both sides thoroughly with hot water. Towel dry and replace the lint screen when dry.

What does AF mean on Maytag Bravos XL dryer?

Restricted Air Flow

What does the code PF mean on a Maytag dryer?

Power Failure

What does l2 mean on a Maytag dryer?

Low or No Line Voltage