How do you run diagnostics on a Cabrio washer?

How do you run diagnostics on a Cabrio washer?

HOW TO ACTIVATE DIAGNOSTIC MODE ON A WHIRLPOOL CABRIO WASHERPress and hold that button for 3 seconds, then release it for 3 seconds.Press and hold it again for 3 more seconds, then release it for 3 seconds.Press and hold for 3 seconds.

What does OL mean on a Cabrio washer?

error code

How do I fix the OL code on my Cabrio washer?

WHIRLPOOL CABRIO WASHER ERROR OL EXPLAINEDMake sure you have not overloaded the machine, remove some clothes if necessary.Number 1 is the most common problem but this error can also be caused by a mechanical issue.

How do I reset my Cabrio washer?

Procedure Detail It’s time to press the on and off button just one time. Now check the machine by rotating the dial until rinse, wash, and stoplight. Now turn the washer off and unplug it for a few seconds. This is the procedure to reset the machine if it’s not properly reset repeat the process one more time.

Why is my washing machine chirping?

If the noise only happens in the spin cycle it may be the bearing but the most likely source of the chirping noise is the brake. The brake rotor and lining may be rubbing together after the brake is released for the spin cycle. Other sources of the noise could be the belt/pulley and/or the pump.

Why does my Frigidaire washer keep beeping?

Washer sounds and beeps Your machine is checking that the water has drained before spinning. Your washer will beep if you have used ‘No Spin’ and at the end of the cycle. If your machine is beeping continuously or giving a musical series of beeps, refer to the ‘Before you call for service’ section.