How do you reset a Maytag Bravos washing machine?

How do you reset a Maytag Bravos washing machine?

Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid….How to Reset a Maytag WasherPress the “Power/Cancel” button.Push the appropriate button to choose a new cycle.Press “Start/Pause.” You have now reset your Maytag washer.

What does SD mean on washing machine?

The “Sd” error code is an indication of Suds Lock (overdose of detergent detected during the wash cycle). High Efficiency (HE) detergent is recommended which is a low sudsing detergent. Note. : Using too much of the recommended HE detergent will also cause too many suds and cause “Sd”.

How do you fix a SD on a washing machine?

Simply put, too much detergent was used and an excessive amount of suds or foam was produced. Adding an additional rinse cycle without adding any more detergent might fix this problem. Sometimes the machine will automatically detects this problem and add a pause and additional rinse cycle in order to break up the suds.

What does 5d on a washer mean?

suds lock

What does lf mean on a Maytag Bravos XL washing machine?

Long Fill

What is a 5d error code?

Did you receive an Sd (may appear as 5d) or Sud Error Code? If Sd or Sud (excess suds) appears in display, you have excessive suds in washer. The washer is running a suds reduction routine. Allow the washer to continue.

How do I fix my 5d Whirlpool washer?

To solve the problem correctly, you need to press PAUSE / CANCEL 2 times or POWER 1 time and then start washing. Stop the washer and take out too voluminous, soft, and fluffy things. Then continue the cycle. Error 5d should disappear because the sensor responded to swollen wool.

What does the code SD mean on a Whirlpool washer?

excessive detergent suds

What does it mean when a washer says f1?

The Cabrio Washer F1 error code happens when the main control board gets a bad signal from the water level pressure switch circuit. This is normally caused by a pinched or ripped water level pressure switch hose. Steps to take to try and remedy this error are listed below.

What does f2 mean on my washing machine?

The F2 error code on the Whirlpool washer is indicated as F02, and means that the washer is taking too long to drain properly. This means there is come kind of problem with the washer’s draining system.