How do you reset a GE washing machine?

How do you reset a GE washing machine?

Motor Reset:Unplug the washer for 1 minute from the electrical outlet.Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid. The motor has now been reset and is ready for you to start a cycle.

Why won’t the spin cycle work on my washing machine?

Check the washing machine’s spin cycle. If the spin cycle works, the motor is operating and the belt is not broken. If the spin cycle doesn’t work, the belt may be loose or broken. Tighten or replace the belt.

Why would my washing machine just stopped working?

Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining. One thing that you can check yourself is the lid switch.

Why is my GE washer not turning on?

If the electrical outlet is receiving power, but the washer won’t start, the power cord might be defective. However, this is very rare. To determine if the power cord is defective, use a multimeter to test it for the cord for power. If the power cord is not getting power, replace it.

Why does my GE front load washer keep pausing?

The door latch can cause a GE frontload washer to pause during a cycle. If the door physically opens, the washer will pause. However, if the door stays locked but the switch is bad then the control will think the door is open and the washer will pause.

How do you reset a Unimac washing machine?

Once the bearings have been lubricated, reset the bearing counter by pressing and holding the STOP, BACK and LCD buttons. Press the arrow buttons until Reset Bearing Timer is highlighted and press ENTER. The counter will reset and the text will change to Bearing Timer Reset.

What does EDR mean on a washer?

water drainage