How do you program a Maytag French door refrigerator control board?

How do you program a Maytag French door refrigerator control board?

Press and hold the Freezer Temperature Down keypad within 3 seconds. Release the door alarm keypad and wait 3 seconds. The control will display PE to indicate the programming mode. Press the Freezer Temperature Down once more.

How do I reset my Maytag refrigerator control board?

Maytag Refridgerator Reset ProcedurePress and hold the Door Alarm Keypad DoorAlarm .Press and hold Freezer Temperature Down Keypad .Release the Door Alarm Keypad DoorAlarm and wait 3 seconds.The control will display PE to indicate the programming mode.Entry is confirmed by pressing the Freezer Temperature Down Keypad once more.

How do you adjust the temperature on a Maytag refrigerator?

If you need to adjust the temperature, wait at least 24 hours between adjustments and then recheck the temperature. To make the Refrigerator colder, adjust the control to the next higher setting. To make the Refrigerator less cold, adjust the control to the next lower setting.

What is vacation mode on a Maytag refrigerator?

Vacation mode is an energy saver feature some older refrigerators. Based on low or no door openings and decreased run time for the compressor, the unit will extend the time between defrost cycles. Thereby saving energy by not defrosting as often.

Where is the thermostat on a Maytag refrigerator?

The thermostat is located in your refrigerator’s control panel in the fresh food section.

Why is my Maytag refrigerator freezing food?

The temperature control thermostat directs voltage to the compressor, evaporator fan motor, and condenser fan motor (if applicable). If the temperature control thermostat is not working properly, it may cause the refrigerant system to run longer than necessary. As a result, the refrigerator will be too cold.

Where is the thermostat located in a refrigerator?

Locate your refrigerator’s defrost thermostat. In freezer-on-top models, it may be located under the floor of the unit, or it could be found at the back of the freezer. If you have a side-by-side refrigerator, the defrost thermostat is found at the back of the freezer side.

How do I know if my freezer thermostat is bad?

If food freezes inside the fridge or its compartments, the cause may be a faulty thermostat. You can use an appliance thermometer to check the thermostat, or try increasing the temperature a couple of degrees. Then wait a day to check whether the food has become unfrozen.

How do you reset a thermostat on a refrigerator?

How to Reset the Compressor on a FridgeLocate the refrigerator power cord on the back of the appliance.Disconnect the power cord from the wall outlet. Turn both the fridge and freezer controls to “Off” or “0” inside the fridge. Adjust the fridge and freezer controls to the desired setting. Allow the fridge up to one day to adjust to a stable temperature.

Does refrigerator have a reset button?

There is no reset button on a refrigerator,but there are many things that can keep it from cooling. Unplugging the refrigerator for several minutes and then plugging it back in will sometimes reboot the electronic control board on the refrigerator (if it has a control board).

Why would my refrigerator stop cooling and then start working again?

Vacuum the coils under or behind the fridge. Clogged coils can cause poor cooling. Check to make sure nothing is stuck in the condenser fan and that it spins freely (models with coils on the back won’t have a fan). Plug in the fridge and make sure the fan runs when the compressor is running.

How long can you unplug a refrigerator?

If the food warms up, the bacteria will reach harmful levels faster.” For this reason, the USDA recommends that food left in an unplugged, unopened fridge for more than four hours be tossed. (Frozen items left in a full freezer stay good for two days; in a half full freezer it’s more like 24 hours.)