How do you clear the error code on a Bosch dishwasher?

How do you clear the error code on a Bosch dishwasher?

To reset the modern Bosch dishwasher, press and hold the start button for about 3 to 5 seconds. On some older Bosch models, the reset feature may be called cancel or drain. These older models require a specific Button Press Sequence or what we in the biz call a Key Dance to complete.

How do you run a diagnostic test on a Bosch dishwasher?

To start test program, press and hold both POWER SCRUB PLUS and REGULAR WASH program buttons, then turn unit on by pressing ON/OFF button. When program buttons are released, lights above them will flash. To end test program, press ON/OFF button. To check each program indicator light, press its button.

What does a blinking red light mean on a Bosch dishwasher?

door not latched

How long should a Bosch dishwasher last?

Did Your Last Dishwasher Last As Long as This Chart Says It Should?clark.com › homes-real-estate › dishwasher-how-long-sho…clark.com › homes-real-estate › dishwasher-how-long-sho…

Why is my Bosch dishwasher saying check water?

The Tap symbol indicates: The water supply filters or aqua-stop hose are blocked. The dishwasher waterflow is too slow. The tap might be jammed or calcified causing low water pressure, or there is a kink in the supply hose / water hose. Please check the water inlet.

How do you check the water level on a Bosch dishwasher?

Should there be water in the filter of my dishwasher?

You’re likely noticing this water as you’re going to remove your dishwasher filters for regular cleaning. Water in this area is actually perfectly normal, useful even. It’s there to keep the seals from drying up. It drains when a cycle starts and is replaced with fresh water at the end of the cycle.

Why is there a little bit of water left in my dishwasher?

One of the most common reasons for water at the bottom of your dishwasher is because food particles or other debris have clogged the drainage system. Check the dishwasher drain and clean the drain basket around the lower sprayer arm, unclogging debris with a wire hanger.

Is water supposed to sit at bottom of dishwasher?

Some water (standing water), usually one to two cups, remaining in the bottom of the tub is normal. Do not plumb other devices into the dishwasher drain hose. The high drain loop prevents back flow of water from the drain into the dishwasher if an air gap is not installed.

Why is water left in bottom of dishwasher?

Water in the bottom of the dishwasher results from clogs in the filter, garbage disposal, drain hose, drain pump, or air gap. When food or sediment build up within these systems, the dishwasher won’t drain properly. Locating the blockage and clearing the debris will solve the problem.

How do you unblock a dishwasher pipe?

How do I remove standing water from my dishwasher?

Line the floor under the dishwasher with towels or newspaper. With a measuring cup or a large ladle, scoop the water from the bottom into a bowl or the sink. When the water becomes too shallow to scoop, soak up the remaining moisture with cloth or paper towels.