How do I reset the combination on my GE washer dryer?

How do I reset the combination on my GE washer dryer?

Unplug the washer for 1 minute from the electrical outlet. Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid.

How do I stop the LED lights from flashing on my GE stackable washer and dryer?

If so, reconnect the wires and reset the washer logic by turning the cycle control knob to the 4 o’clock position, press and hold the start/pause button until the light blinks (3-5 seconds wait). Then, while holding in the start/pause button, turn knob to the 6 o’clock position (blinking light should stop).

Why won’t my GE washer agitate or spin?

Common solutions for: GE Washer won’t spin or agitate. Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the lid switch assembly fails, the washer will not spin. To determine if the lid switch assembly is defective, use a multimeter to test the lid switch for continuity.

How do you reset the spin cycle on a GE washing machine?

Motor Reset:Unplug the washer for 1 minute from the electrical outlet.Plug the washer back in and lift and lower the lid 6 times within a 12 second period. You have 30 seconds to start lifting and lowering the lid. The motor has now been reset and is ready for you to start a cycle.

Is there a reset button on GE washers?

To reset washing machines that use the GE Hydrowave system, start by unplugging the washer for one minute. Plug the washing machine back in and then within 30 seconds, quickly open and close the lid six times. Raise the lid at least 2 inches and make sure it closes each time. This should complete the motor reset.

How long does a GE washing machine last?

A GE machine may last longer than a Kenmore and, yet, it may not. The range is more specific with a GE, and you can expect to get 11 or 12 years out of a machine.

Is the agitator supposed to spin?

The agitator can spin along with the basket or it could sit stationary depending on the amount of friction between the agitate shaft and the basket drive shaft. The agitator will normally spin along with the basket.

Why does the drum in my washing machine shake?

When shock absorbers weaken or become damaged, unbalanced loads will cause the washer to shake or move and the machine will often make a loud banging sound during the spin cycle. If the symptom is not corrected, it can lead to damage to other components.

Why does my washer jump around?

The most common cause of when a washing machine jumps and bangs on spin is an uneven load. Occasional jumping around may not be anything to worry about if it isn’t banging too much. A general rocking around of a washing machine on spin may just be caused by an uneven floor, or an un-level washing machine.