How do I reset my Maytag Bravo XL washer?

How do I reset my Maytag Bravo XL washer?

How do I reset my Maytag Bravos XL washer?Press the “Power/Cancel” button.Push the appropriate button to choose a new cycle.Press “Start/Pause.” You have now reset your Maytag washer.

What is sanitize with Oxi on Maytag washer?

Hi Magz – The Sanitize With Oxi cycle, when using an Oxi additive along with your detergent, is designed to remove 99.9% of bacteria found in home laundry. Measure the detergent and the Oxi products carefully using the amounts recommended by the products’ manufacturers. Use the amounts for a large heavily soiled load.

How do you reset the sensor on a Maytag washer?

How to Reset a Maytag WasherPress the “Power/Cancel” button.Push the appropriate button to choose a new cycle.Press “Start/Pause.” You have now reset your Maytag washer.

How do you run a diagnostic test on a Maytag washer?

You will need to start the diagnostics mode again, but this time turn the Centennial washer’s cycle knob right until only the “spin” light is lit and press “start”. The washer will do a quick cycle that will test all the washer functions.

What does the shift actuator do in a washing machine?

It shifts the unit between spin and agitate. You will see if it has came off the lever post and if not, you will check and make sure it moves between agitate and spin.

How do you know if your washing machine is going out?

6 signs it’s time to replace your washing machineThe drum won’t spin at the end of the cycle. The machine still works but the water hasn’t drained. It’s more noisy than it should be. You don’t trust it with your clothes. It’s no longer big enough for your family. It’s much older than your latest smartphone.

How do you know if your washing machine motor is bad?

The five most common signs of motor issues are listed below.Washer Won’t Pump or Spin. It may happen that the washing machine fails to pump water in and out, as well as spin. Pumps, but Won’t Spin. Again, the lid switch could cause the washer to pump water, but not spin. Washer Won’t Agitate. Clothes Still Wet.

How do I know if my carbon brushes need replacing?

As a general rule, if either brush has worn to about a quarter inch long, it is time to replace it. If the carbon (a brush is essentially a carbon block with a metal spring tail) shows any signs of breakage, crumbling, or burning, the brush needs replacing.