How do I reset my Kenmore dishwasher?

How do I reset my Kenmore dishwasher?

Press the heated dry button, and then the normal wash button. Repeat this step: press heated dry and normal wash again. After this four-push sequence, with no more than a second between each push, close and latch the dishwasher. It should begin to do a short cycle that allows the machine to reset.

How do I reset my Kenmore Quiet Guard dishwasher?

To reset it, you will have to have the door open. It can not be latched. Press “Heated Dry,” “Normal,” “Heated Dry,” “Normal” within three seconds of the first pressed button. Now close the door, this should reset your dishwasher.

Why won’t my Kenmore Ultra Wash dishwasher start?

Common solutions for: Kenmore Dishwasher won’t start. If the door switch is defective, the switch will prevent the dishwasher from running even when the door is closed. To determine if the door switch is at fault, use a multimeter to test the switch for continuity. If the switch does not have continuity, replace it.

Why is my Kenmore dishwasher clean light blinking?

The blinking clean light normally indicates that the control on the dishwasher detected a problem with the heating circuit. The dishwasher will step through a short (10 minute) test cycle and then the control will be reset. You can cancel the cycle at any time after it is started by pressing the CANCEL button.