How do I fix the Sud error on my washing machine?

How do I fix the Sud error on my washing machine?

How to fix the errorWait for a little for the suds to dissipate. Clean the drain filter upon completing the wash cycle;Remove excess powder by running the washing machine without clothes and setting a long wash cycle and high temperature;Change the detergent if you detected an oversudsing condition constantly.

Why does my washer keep saying Sud?

It means you are using detergent improperly. If your washing machine has the word “SUDS” on the display, it has detected an over-sudsing condition, and will stop for a short period to allow the suds to dissipate. This error code is usually caused by too much detergent, or the wrong type of detergent.

Is there a way to reset a washer?

Turn the machine off at the powerpoint, wait for one minute, and then turn it back on. If you see no change, you can try a Master Reset. This will reset all of the onboard componentry and is often successfully used by appliance technicians. Open and close the door of the washing machine 6 times within 12 seconds.

Why does my Whirlpool washer stop mid cycle?

Some of the most common faults that will make your washer stop mid cycle include thermostat failure, problems filling up with water for the rinse cycle, or even pump problems that prevent your washer from draining. One thing that you can check yourself is the lid switch.

How do you stop a whirlpool mid cycle washer?

What to do if Your Whirlpool Washer Stops in Mid-CycleCheck to make sure the washer is still plugged in. Make sure the circuit breaker in your electrical panel box has not been tripped. If your washer is plugged in and the circuit breaker is fine, the next thing to consider is whether the lid switch is working properly.