How do I fix Internet Explorer error on my Kenmore Elite washer?

How do I fix Internet Explorer error on my Kenmore Elite washer?

ERROR CODE IE Inlet water supply error Check the water supply faucets behind the washer to make sure they are fully open. Check the fill hoses for kinks or freezing (in winter). Check the inlet water valves. If the valves are defective, replace the inlet water valve assembly.

Why does my washer keep saying IE?

An IE error code indicates that the washer was unable to fill with water. During cold and freezing weather conditions, an IE error code could mean the water in the water supply lines are frozen. Once the temperature increases above freezing, the water supply will resume.

How do I reset my Kenmore Elite washer?

How to Reset a Kenmore Elite HE WasherPress the “Stop” button twice, and then press the “Power” button.Choose a wash cycle (e.g. “Normal”), and then choose your wash options (e.g. “Hot/Cold” or “Cold/Cold”).Press the “Start” button to complete the reset process and restart the washing machine.

How do I fix the code on my Kenmore washer?

Kenmore front-load washer LE error codeOverloaded washer. Make sure the washer isn’t overloaded. Too much detergent. If you see lots of suds in the tub, let the washer sit idle for 30 minutes so the foam dissipates. Drive system obstruction. Loose wiring or defective drive motor.

How do I reset my Kenmore front load washer?

To perform the Master Reset, carefully unplug the washing machine from the power outlet and leave it unplugged for one minute. After one minute is up, plug the washer cord back into the wall. Next, open and close the door of the washing machine 6 times within 12 seconds to send a “reset” signal to all the components.

How do I run diagnostics on my Kenmore Elite washer?

Here is what I did to run a diagnostic.With the washer empty, close the door.Push “control/on” or “Start”Select “Drain/Spin”Select “No Spin” by pressing SPIN SPEED touchpad.Push “PREWASH” option four times within 5 seconds. C:00 should light up and begin the diagnostic.

How do you fix a Kenmore front load washer that won’t drain?

5:26Suggested clip · 121 secondsLG/Kenmore Front Load Washer Won’t Drain? Drain Hose – YouTubeYouTubeStart of suggested clipEnd of suggested clip

Why is my washer still soaking wet after a wash cycle?

The most likely culprit for a washer that spins but still turns out soaked clothing is a drain hose problem. Often with this issue, whatever is causing it to not drain during the spin cycle means the water isn’t draining off fast enough and is essentially flowing back into the washer drum, re-soaking your clothing.