How do I fix error f9 e1?

How do I fix error f9 e1?

Possible Solutions If F9 E1 (drain pump system problem – long drain) appears in display, the washer is taking too long to drain water. The drain may extend more than 4.5″ (114 mm) into standpipe. Check plumbing for correct drain hose installation. Use drain hose form and attach securely to drainpipe or tub.

What does e01 and f09 mean on a washing machine?

LONG DRAIN TIME

How do I fix e1 error on my washing machine?

If F8 E1 or LF (too long to fill) appears in display, it means the washer is taking too long to fill. It’s possible the drain hose extends more than 4.5″ (114 mm) into standpipe. Check plumbing for correct drain hose installation. Use drain hose form and attach securely to drainpipe or tub.

Do Whirlpool washers have a reset button?

How to Confirm You Have Reset Your Whirlpool Washing Machine. Rotate your dial until you have the following three lights illuminated: RINSE, WASH, and STOP. Then turn off your washer and unplug it for ten seconds. When you turn it back on it should be reset.

Why does my washer keep saying sensing?

What the washer is doing when it is sensing is the positioning sensor is checking the position of the motor with the tub. When it’s working properly, you’ll hear the motor start and stop. The clutch engages and the basket will move.

Why is my washer not working?

If your washer fills with water but doesn’t agitate, the problem is likely to be a faulty lid switch, a broken belt, or a problem with the motor. (Note: Direct-drive washing machines do not have belts.) Anatomy of a top-loading washing machine.

How do you reset a front load washer?

How to reset the washing machine:Press POWER to turn the washer off.Unplug the washer from the power outlet or turn the circuit breaker to the unit off.With the power disabled, press and hold the START/PAUSE button for 5 seconds.Plug the washer back in, or turn the circuit breaker back on.

How do you fix a stuck button?

Clean around buttons with Q-tips and alcoholFirst, unplug the controller.Dip the Q-tip into the rubbing alcohol, dabbing off any excess.Rub the Q-tip around the button that is sticking several times, getting as far into the crevices as you can.

How do you fix a jammed phone button?

Fix a Stuck Button on your Android Smartphone or Tablet:Prepare some isopropyl alcohol, Q-tips (or any cotton swabs), as well as a canned air duster;Turn off your Android device;You must also remove the battery, if possible, just to be on the safe side;

How do I get my volume button unstuck?

your best bet is to grab some small metal flat too to try and slide it into the housing where the buttons are. You will then try to pull the buttons back out or see if there is any metal that may be obstructing the button from coming back out.

How do I turn off Safe Mode if my volume button is broken?

If you want to get rid of/disable “Safe Mode”.First turn off the phone.Next press and hold “Power” until you see the manufacturers logo on the screen, then release the power button.”Quickly” press “Volume Down” and hold it for few seconds until you see the message “Safe Mode: OFF” or something similar.